This is the latest evolution of our serial LCD. Included on a single board is a 16x2 LCD and an embedded circuit based around a PIC 16F88. The on-board PIC takes a TTL serial input and prints the characters it receives onto the LCD. The installed firmware also allows for a number of special commands so you can clear the screen, adjust the backlight brightness, turn the display on/off, and more.

Communication with SerLCD requires 5V TTL serial at a default baud rate of 9600bps (8-N-1). You can adjust the baud to any standard rate between 2400 and 38400bps. The power (VDD), ground (GND) and RX pins are all broken out to both a 0.1" pitch header as well as a 3-pin JST connector.

SerLCD has the ability to dim the backlight to conserve power if needed. There is also a potentiometer on the back of the display to adjust the contrast.

Features:
  - Embedded PIC 16F88 utilizes onboard UART for greater communication accuracy
  - Adjustable baud rates of 2400, 4800, 9600 (default), 14400, 19200 and 38400
  - Operational Backspace
  - Greater processing speed at 10MHz
  - Incoming buffer stores up to 80 characters
  - Backlight transistor can handle up to 1A
  - Pulse width modulation of backlight allows direct control of backlight brightness and current consumption
  - All surface mount design allows a backpack that is half the size of the original
  - Faster boot-up time
  - Boot-up display can be turned on/off via firmware
  - User definable splash screen
  - Dimensions
    - PCB: 103x36mm
    - LCD: 71.4x26.4mm